Inserts - Hilti Malaysia

TE-C-HSC-B Stop drill bit Stop drill bit for HSC installation (TE-C)

TE-C-HDA-B Stop drill bit Stop drill bit – required for installation of HDA undercut anchors

TE-Y-HDA-B Stop drill bit Stop drill bit – required for installation of HDA undercut anchors

HKD-TE-CX-B SDS Plus stop bit (long) SDS Plus (TE-C) hammer drill stop bit for HKD-TE-CX long HKD setting tools

HKD-TE-CX-B SDS Plus stop bit (short) SDS Plus (TE-C) hammer drill stop bit for HKD-TE-CX short HKD setting tools

HKD-TE-CX Stop bit SDS Plus (TE-C) stop bit for HKD anchors

Stepped drill bit TS-BT 5.3-95 S

Stepped drill bit TS-BT 5.3 HC

Stepped drill bit TS-BT 5.3-65 S

TX-BT 4.7/7 Stepped drill bit Stepped drill bit for pre-drilling holes for new-generation X-BT fasteners

TE-CD (SDS Plus) Metric hollow drill bit Ultimate SDS Plus (TE-C) hollow drill bit for virtually dust-free hammer drilling in concrete

TE-YD (SDS Max) Metric hollow drill bit Ultimate SDS Max (TE-Y) hollow drill bit for virtually dust-free drilling in concrete

Stepped drill bit TS-BT 31-74 PFP PFP removal drill bits for predrilling accurate holes and removing coatings from PFP coated steels

Stepped drill bit TS-BT 5.5-74 S Stepped drill bits for predrilling accurate holes or removing coatings for S-BT threaded screw-in studs on aluminum and steel

Stepped drill bit TX-BT 31-74 PFP PFP removal drill bits for predrilling accurate holes and removing coatings from PFP coated steels

S-SY B Screwdriver bit Customised screwdriver bits for Hilti screw fastening systems

S-BH Bit holders/accessories Bit holder and accessories for use with screw fastening inserts

SI-S 1/2" L Deep impact socket 1/2" long impact socket for tightening bolts and anchors

SI-S 1/2" S Short impact socket 1/2" (inch) short impact socket for tightening bolts and anchors

SI-S 1/2" DW Deep impact socket 1/2" (inch) long impact socket for tightening bolts and anchors, with magnetic impact and thin wall adaptation

S-IS Impact socket accessories Accessory for impact sockets

Socket wrench insert X-NSD 1/4" Nut setter for tightening flange nuts on threaded studs

TE Tool shaft Shank for sockets

S-TB Torque bar Torque-controlled socket wrench for setting HSA anchors